Benchables- What I'm doin'.

[Luke]

hi5 Some good projects in the works mate.

Let me know when ya fingers better, we will start a paint pattern thread.

[slowlylearning]

Busy indeed

Finally hadc the time and motivation to do myself a set of wheels just for fun... they're just some tristy-spoke curvy faced things... Showwheels or Intro or something, not sure...

Tested the proportions on the mule Camaro





Didn't like the look so I did what anyone else would do, started a whole new build just for the wheels

Going for a showcar/butnout car look... Gonna model up a hirise blower setup and have it setup in curbside fashion, don't much wanna go making a fully custom chassy/engine/suspension etcetc, curbside's good enough for me





Did a mockup with those weird-spokes wire wheels in chrome on the Caprice kit

(Al that kit you sent me is being built in September for a radical lowrider build-off for a model magazine )

[slowlylearning]

hi5 Some good projects in the works mate.

Let me know when ya fingers better, we will start a paint pattern thread.

Will be doing some patterning very soon 8)

[Luke]

New wheels look bad ass dude, look better under the Camaro I reckon.

Hilux ideas sounds like something we all love the over the top burnout cars

Got to love the glasshouse drool

hi5 Some good projects in the works mate.

Let me know when ya fingers better, we will start a paint pattern thread.

Will be doing some patterning very soon 8)

Awesome, the Rivi is just about ready for the silver basce coat

[slowlylearning]

Awesome, the Rivi is just about ready for the silver basce coat

I might draw up a few of the billet Showwheels and Intro sets and see which I like, but the wigglyspokes are winning so far Chrome will make em opo... and brakes, cant forget brakes!

I'm gonna try and get the glasshouse in its base colour today if I can be bothered... Doing silver as a base, then one colour of pattern and I wanna try a full coat of candy

[slowlylearning]

Did this setup thingy tonight, just a few more bolts to go and then we'll see how many details don't print Kind of doing it as a 1pc curbside engine plate part where I can just chop a hole in a bonnet and poke this piece through. Nice and easy... Hopefully.
Decided to try modeling one of those weird Holley throttlebody/carb lookin thinks. Lord knows if I actually got it right

Shotgun scoop is next after the final bolts and details.

[Luke]

Damn dude that is impressive bowdown
Shot gun scoop

[B61 MACK]

agreed whathesaid

[sandboarder]

That a wild blower setup!! 3D drawing looks really impressive and complicated. You have some really nice projects in the pipe line. Can’t wait to see what you do with them all

[slowlylearning]

Cheers fellers

Been plugging away







It's all gonna be Alclad and I'll just highlight some bits and bobs if I can be bothered