Another kitbash 32 Ford

[B61 MACK]

Looking wild so far going to be wicked little ride.

[sandboarder]

Final pics for now. Back to work tomorrow but I’ll continue to work on the rear suspension next and get a final ride height. I’m happy with the front atm.









Starting to match the idea in my head already. Still heaps to do tho to make this work.

[Luke]

Progressing well with the cutting and shutting, and of to a good start for sure. Looking bad ass already in the latest mock up pics.

[slowlylearning]

That's a no-nonsense stance for sure! Very mean looking

[sandboarder]

Been about colours and have been military. So not sure if I want it olive drab green, a dessert tan or a flat blue dunno I want to paint the motor and diff but need to work out colours/themes. I should just paint it all navy Ford blue until I decide on a body colour.

[B61 MACK]

Have a look at Tamiya rattle can military range of colours you might find colour, you could do a two tone on it.
AS-19 intermediate blue, AS-5 light blue Luftwaffe.

[sandboarder]

Those are some of the cans I was of Al, no two tone tho. Just one colour for this one.

All that’s left of the Thunderbird rear tubs dunno

[Luke]

how much of them will you actually be able to see once installed ??

[sandboarder]

Not much lol but the four link does hang low.

I originally cut the drag chassis in half just in front of the tubs. I’ve narrowed them to suit the 32’s fenders. Kept one tail shift loop. Trimmed all of the rear off which included a fuel cell because it wouldn’t fit under the 32’s boot. When in place it looks good but it’ll have to set the ride height when I install the tubs so I’ll paint and finish the rear suspension next. Front of the drag chassis from about the seats forward will be used.

[B61 MACK]

Do body one colour fenders and chassis another colour